Quick Start Guide

Intended for ages 6 to adult.

 

WARNINGS:

• Never unplug with stick! Hockey sticks are highly conductive.

• Never drop puck on gameboard. Place to play or use SuperDeker Puck Ramp.
• Never subject game or components to extreme hot or cold.
• Never subject game or components to rain or wet conditions.
• Never modify game or components in anyway.
• Use eye protection.
• DANGER: To prevent electric shock, do not immerse in water or wipe with clean and cloth.
• Do not leave game plugged into outlet for extended periods of time.
• Never wear skates on SuperDeker, as this will void warranty.
• Puck is only for use on the SuperDeker.
• Puck is not for shooting.
• To avoid injury, closed toe shoes must be worn.
• Save this sheet for future references.

 

HELPFUL HINTS:

For best results, the game should be placed away from any direct sunlight as this makes gameplay more difficult. Make sure you remove plastic cover from the ice surface and setup on a level surface before you start using SuperDeker Pro.

 

CAUTION-ELECTRIC TOYS:

Not recommended for children under 6 years of age. As with all electronic products, precautions should be observed during handling and use to prevent electric shock.

 

INPUT: 100-240V ~ 50/50Hz. 0.3A Max

OUTPUT: 5V  1.0A

Operating Temperature: 0°C - 40°C Storage Temperature: -20°C - 80°C

 

FCC WARNINGS:

Note: This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reason- able protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

 

Warning: CHOKING HAZARD - Small parts.

 

Canada Patent NO. 2436020

US Patent No. 7850514B2,

7999694B2 - Patent Pending

 

QUICK START:

1. Remove contents from box.
2. Slide foam shipping protectors out.
3. Remove plastic coating from surface.

 

 

 

 

 

4. Connect panels together with score board facing away from you.

 

 

 

 

 

 

5. Screw in pegs, then insert bar into the surface. Bars should be on the bottom of the game. Make sure pegs are tightened.

 

 

 

 

 

 

6. Place rebounder bands on each of the end pegs.

 

7. Lightly spray entire ice surface and down the side of puck with Zero Friction Ice Spray and wipe off with cloth. Three to four sprays is all you need per panel.

 

8. Connect USB power cable to scoreboard and plug into outlet to charge internal battery.

 

9. Press the power button to turn on the SuperDeker.

 

10. Pass the puck over the light to start first game.

 

RESET THE SUPERDEKER:

Pushing the reset button will power cycle the SuperDeker.

 

MAINTENANCE:

DO NOT USE ANY ALCOHOL OR AMMONIA BASED CLEANER. Using these types of cleaners will dry the plastic and make it brittle. You can keep the game optimized by taking a cloth with a little Zero Friction Spray (one or two sprays) and apply to the puck and ice.

 

Use white tape on your stick to avoid making black marks on the SuperDeker Pro.

 

 

 

Scan QR Code to learn about game modes and download the SuperDeker App, available for Apple and Android.